ELTAKO Universal Dimmer without Neutral Connection, especially for LED – 61100832

Without N-connection, power MOSFET up to 200W. Stand-by loss only 0.5 Watt. With control inputs for light pushbuttons and light switches. Minimum brightness, operating mode and dimming speed adjustable. For flush mounting. 45mm long, 45mm wide, 18mm deep. Universal dimmer switch for R and C loads up to 200W, depending on ventilation conditions. Dimmable 230V LED lamps and ESL in trailing edge mode up to 200W or in leading edge mode up to 40W, depending on ventilation conditions. For dimmable 230V LED lamps that glow slightly even when switched off, a basic load element GLE must be connected in parallel to the lamp. L-loads (inductive loads, e.g. wound transformers) must not be connected. Zero-crossing switching with soft-on and soft-off for lamp protection. Supply, switching and control voltage 230V. Minimum load 4W. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. The set brightness level remains stored when switched off (memory). Memory can be switched off by turning the upper rotary switch three times to the right stop (max). Then ESLs can also be switched. To switch memory back on (factory setting), turn three times to the left stop (min). In the event of a power failure, the switching position and brightness level are stored and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and overtemperature shutdown. The minimum brightness (fully dimmed) can be set with the upper %Lamp rotary switch. The lower dim speed rotary switch selects between leading edge (P-AN) or trailing edge (P-AB) mode, sets the dimming speed and simultaneously changes the duration of soft-on and soft-off. In cases where light switches cannot be replaced by light pushbuttons, a separate control input for light switches is available: If the closed switch is briefly opened again, it will dim until it is briefly opened again. The dimming direction changes automatically at the two turning points. Additionally, the direction can be changed by briefly opening the switch twice. With nursery circuit (only when controlled with pushbutton): When switched on with a longer pushbutton press, it switches on after approx. 1 second with the lowest brightness and, as long as the button is pressed, slowly dims up without changing the last stored brightness level. With sleep circuit (only when controlled with pushbutton): A double pulse dims the lighting from the current dimming position to the minimum brightness and switches it off. The max. dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. By briefly pressing the button, it can be switched off at any time during the dimming process. A long press during the dimming process dims up and ends the sleep circuit. Without N-connection, therefore suitable for mounting directly behind the light pushbutton or light switch, even if no N-line is available.